Bypass Flow

BypassFlow component.

Allows user to easily configure workflow route to take during invocation. The upper port is used when the config box is ticked/checked. The lower port is used if it isn't.

This is actually just an IF node with modified configuration, so at the other end of the branch, there should be an End If or Case End node to bring the flows back together. A plain IF Switch node could do the job equally, but the intention here is to make it clearer that the intent is to temporarily Bypass the particular flow/branch.

30 April 2021 @takBB Brian Bates

Input ports

1. Type: Table
   Input data flow

Output ports

1. Type: Table
   Standard Flow
   The standard flow to use if the node has not been configured to "bypass". Attach your standard node/metanode to this port
2. Type: Table
   Bypass Flow
   The data flow route to use when the node has been configured to bypass. Attach your alternate route to this port